Complete the form below">

LIQUID TEMPERATURE CONTROL EQUIPMENT Complete the form below, then press the 'Submit to WAK' button.  The information will be transferred to WAK Plastics & Machinery via email. CONTACT INFORMATION: Company Name: Contact: Date Submitted:   Date Required:  Address: City: AK AL AR AZ CA CO CT DE DC FL GA HI ID IL IN IA KS KY LA MA MD ME MI MN MO MS MT NC ND NE NH NJ NM NV NY OH OK OR PA RI SC SD TN TX UT VT VA WA WV WI WY Zip: Phone: Email:  Fax: PRODUCT INFORMATION: Type of Molding Machine: Size (Tons): Dimensions of Mold: (L X W X H) Mold Weight: Mold Material: Process (Control) Temperature Required: Preheat Time Required: Insulation (if any): Temperature Control: (Water, Oil, Water/Glycol Mix) Number of Zones Heating/Cooling: Coring or Cooling/Heating Lines: ZONE 1 ZONE 2 ZONE 3 ZONE 4 Inlet: Quantity of Lines Sizes of Lines Outlet: Quantity of Lines Sizes of Lines Material Molded: End Product: Shot Weight: Shot Cycle Time: Voltage: Volts: Phase: Hertz:   Control Requirements: Solid State: Other: Microprocessor: Special Control Capabilities: Prior Equipment: Amount of Cooling Required If Known: (BTU's/Hr or Tons) Type of Condenser Desired: Air Cooled Water Cooled If Air Cooled - What is Ambient Air Temp Range for Area of Installation: °F If Water Cooled - What type of condensor water cooling: City Water Cooling Tower Central Chiller Flow Rate of Water: Water Temperature: When planning to use fluid other than water (in process fluid loop), supply the following information Fluid Type: Brand Name (if any): Specific Heat: Thermoconductivity Specific Gravity: % by weight: